SA-J08 EDGE (hal etu)

Specna Arms SA-J08 EDGE™ HAL™ ETU airsoft Carbine with Magnus TDC chamber

The presented model featuresa rotating Hop-Up Magnus TDC (Top Down Center) chamber, which will guarantee even better performance of the replica, and the HAL™ ETU system

Features of the HAL™ ETU Module:

• trigger detection based on magnetic sensors and Halleffect
• active trigger
• binary trigger
• adjustable trigger sensitivity (5 levels from 20 to 100% )
• adjustable pre-cocking (6 levels )
• programmable AUTO fire modes (full auto, semi, 3-rd burst, 5-rd burst)
• programmable SEMI fire modes (semi, binary, AUG, sniper )
• easy programming via trigger
• low battery alarm

EDGE™ is a line of Specna Arms replicas that combines a range of solutions and technologies that are difficult to find in other replicas on the market. It is a line that focuses both on very good external workmanship, solutions that increase the versatility of the replica, prolonging its life, facilitating the diagnosis of malfunctions, as well as susceptibility to power tuning.Straight out of the box you get a replica in which you do not have to make any modifications, but if you want – they will be fabulously easy.

Specna Arms J-Series™ airsoft replicas are mostly made out of steel construction The outer barrel, protective frame, slide cover, trigger guard, magazine catch, firing pin, dummy gas tube, sling swivel, ejector cover, slide stop, slide, and all pins and screws are made of steel. The remaining metal parts are made of zinc and aluminum alloy, and a special surface finish gives the replica a very realistic appearance. As in the original, the trigger guard and magazine are made of polymer, but the front part of the handle and the gas tube cover are made of lacquered wood.

Inside, you will find the ORION™ V3 gearbox, which is characterized by high reliability. The mechanism is prepared for further tuning.

Contents include:

• Polymer piston with full steel jaw
• Double sealed aluminium cylinder head
• Aluminium sealed nozzle
• Polymer sealed piston head
• Polymer bearing spring guide

Features of the replica:

• HAL ETU system
• Rotary Hop-Up Magnus TDC (Top Down Center)chamber
• Sheet steel body
• Single-piece steel outer barrel
• Quick-change spring system ESA2
• side dovetail mounting rail
• plenty of room for a stick-type battery under the breech cover (LiPo ready)
• shellised, side-folding stock

Package include:

• 2 x mid-cap S-MAG magazine
• Cleaning rod
• Replica
• Allen key
• Small Tamyia – Deans adapter
• BBs speedloader
• M90 additional spring

Package exclude:

• The set does not include the battery nor charger

NOTE!!!
When starting the replica for the first time, immediately after connecting the battery, hold the trigger in SAFE mode for about 5 seconds to activate the HAL™ module.